Symmetricom TimeProvider 1100 Reference Manual page 57

Table 2-6. ED-SYNC – Keywords and Values (Continued)
<keyword> <value>
QLEVEL 1
Note: QLEVEL is
used when an
input cannot
2
determine the
received quality
level. If QLEVEL
3
is provisioned
below the quality
4
level of the local
oscillator, the
input is
5
disqualified. The
input QLEVEL
setting determines
6
if the switching
strategy is
7
revertive or
non-revertive.
This setting is
8
used when
REFMODE is set
to AUTO.
9
PRIORITY 1
2
3
4
Note: If the QLEVEL on all inputs are equal, then the input with the highest
PRIORITY is selected. The input PRIORITY settings determine if the switching
strategy is revertive or non-revertive. This setting is used when REFMODE is
set to AUTO.
QLEVEL
PRIORITY
097-58001-01 Revision E – September 2006
Description
<aid> = GPS
The user-assigned quality level of the GPS input is
specified as PRC/PRS (primary reference
clock/source).
The user-assigned quality level of the GPS input is
specified as UNK/STU (sync traceability unknown).
The user-assigned quality level of the GPS input is
specified as TYPE II/ST2 (stratum 2).
The user-assigned quality level of the GPS input is
specified as TYPE I.
The user-assigned quality level of the GPS input is
specified as TYPE V/TNC (transit node clock).
The user-assigned quality level of the GPS input is
specified as TYPE III/ST3E (stratum 3E).
The user-assigned quality level of the GPS input is
specified as TYPE IV/ST3 (stratum 3).
The user-assigned quality level of the GPS input is
specified as 811OPT3/SMC (G.811 option 3 SONET
minimum clock).
The user-assigned quality level of the GPS input is
specified as DUS (do not use for timing
synchronization).
The priority level of the input is set to 1.
The priority level of the input is set to 2.
The priority level of the input is set to 3.
The priority level of the input is set to 4.
<aid> = PRS
Refer to the QLEVEL description under the <aid> =
GPS heading in this table.
Refer to the PRIORITY description under the <aid> =
GPS heading in this table.
Chapter 2 TL1 Command Syntax and Description
Edit Sync (ED-SYNC)
TimeProvider TL1 Reference Guide
Default
1
1
57