Symmetricom TimeProvider 1100 Reference Manual page 167

Table C-1. Event Identifiers (Continued)
Event ID
or Event Description
CONDTYPE
INPREF Indicates when the
system automatically
selects a new reference
input.
Allows the user to
manually select the input
to be used for the system
reference. The reference
selection mode
REFMODE must be set
to FORCED.
LOCTIM The system local time
offset was changed.
REFMODE Allows the system to
automatically select the
reference input or allow
the user to select the
reference.
TIMCHG The system time was
changed.
UTC Indicates UTC time was
determined by GPS
interface.
CKTIDCHG A user has modified the
Circuit ID for the output.
FREEFLT Defines if the Retimer
mode operates or not
when the LO enters
Free-run mode of
operation. The output
groups are provisioned
for fault strategies.
097-58001-01 Revision E – September 2006
AID
Default Value
TYPE
T1 PRS
EQPT (00)-00
EQPT AUTO
EQPT hh-mm-ss
EQPT hh-mm-ss
Retimer Event Codes
T1 GPS
T1 CUTTHRU
Appendix C Events
Value Description
PRS – Select PRS input
INP1 – Select Input 1
INP2 – Select Input 2
GPS is selected as system
reference only in PRR mode of
operation.
(hh) – Hours offset +/-12
mm – minutes offsegt 00 to 59
AUTO – System uses Qlevel
and Priority to select the
system reference.
FORCED – The user selects
the system reference, if the
selected reference fails the
system reverts to AUTO mode
for reference selection.
hh – Hours (24 hour clock)
mm – Minutes
ss – Seconds
hh-mm-ss
The ID can be up to 40 characters
in length.
RETIMER – In fault mode the
output signals are retimed
CUTTHRU – In fault mode the
cut-thru mode is enabled, and
output signals are not retimed.
TimeProvider TL1 Reference Guide 167