Symmetricom TimeProvider 1100 Reference Manual page 152

Appendix B Alarms
Table B-1. Alarms (Continued)
Alarm ID
Alarm Condition
or
Description
CONDTYPE
INPFRQ The specified input port's
calculated received
frequency is exceeding
the pull-in range of the
local oscillator. The
received signal's
calculated frequency
alarmed condition
disqualifies the input as
a possible reference.
After INPFRQ is set, the
alarm clears when the
input frequency is within
the defined pull-in range
limits.
INPTRR The specified CC input
port has a Tip/Ring
reversal on it's
connection to the system.
EXDSC Input has had excessive
discontinuities. This is
indicated when there
are more than 3 signal
faults of the same type
within a 5-minute
window. The alarm
clears when the 5-
minute window contains
less than 3 alarms of the
same type.
MTIE Input has exceeded at
least one of the MTIE
alarm thresholds.
E422FAULT The EIA-422 Output
module is not functioning.
<aid> = RTMA[-p] | RTMB[-p] | RTMC[-p]. | RTMD[-p]
S1LOS LOS on Side 1
S2LOS LOS on Side 2
EXSLIP Excessive Slip Rate
RTMFAULT The Retimer module is
not functioning properly
152 TimeProvider TL1 Reference Guide
AID Service
Type Affecting
T1 NSA
T1 NSA
T1 NSA
T1 NSA
<aid> = E422A | E422B | E422C | E422D
T1 NSA
T1 NSA
T1 NSA
T1 NSA
T1 NSA
Error Error
Delay Delay
Default Editable
SSU PRS SUB
IMMED NO MN
IMMED NO MN
IMMED NO MN
IMMED NO MN
IMMED NO NA
IMMED NO MN
IMMED NO NA
IMMED NO NA
IMMED NO' NA
097-58001-01 Revision E – September 2006
Alarm Default
Level
MN NR
MN MN
MN MN
MN MN
NA NA
MN MN
NA NA
NA NA
NA NA