Symmetricom TimeProvider 1100 Reference Manual page 154

Appendix B Alarms
Table B-2. Alarm Code Condition Descriptions (Continued)
Alarm ID Set Alarm Condition Description
IOCSTATE IOC State has Changed, Unequipped
SYNTHEOR Output Generator Exceeded Pull-in Range
IOCSTATE IOC State has Changed, Unequipped
SYNTHEOR Output Generator Exceeded Pull-in Range
ANTCOMM GPS Antenna Comm Fault
GPSPOS GPS Antenna Position Unknown
GPSPWR GPS Power Fault
GPSSYS GPS System Fault
GPSTRK GPS is Not Tracking Satellites
INPDISQ Input Disqualified as Possible Reference
INPLOS LOS Fault
INPPHASE Phase Error Exceeded Threshold
EXDSC Excessive Discontinuity Fault
MTIE MTIE Threshold Exceeded
FFOFF FFOFF Threshold Exceeded
TPIUSIG TPIU Signal Fault
INPDISQ Input Disqualified as Possible Reference
INPLOS LOS Fault
INPFRQ Frequency Threshold Exceeded
INPPHASE Phase Error Exceeded Threshold
EXDSC Excessive Discontinuity Fault
MTIE MTIE Threshold Exceeded
FFOFF FFOFF Threshold Exceeded
154 TimeProvider TL1 Reference Guide
Clear Alarm Condition Description
IOC1 Alarm Conditions
IOC State has Changed, Equipped
Output Generator Within Pull-in Range
IOC2 Alarm Conditions
IOC State has Changed, Equipped
Output Generator Within Pull-in Range
GPS Alarm Conditions
GPS Antenna Comm Fault Cleared
GPS Antenna Position Known
GPS Power Fault Cleared
GPS System OK
GPS is Tracking Satellites
Input Qualified as Possible Reference
LOS Fault Cleared
Phase Error Within Threshold
Excessive Discontinuity Cleared
MTIE Within Threshold
FFOFF Within Threshold
TPIU Signal Fault Cleared
PRS Alarm Conditions
Input Qualified as Possible Reference
LOS Fault Cleared
Frequency Within Threshold
Phase Error Within Threshold
Excessive Discontinuity Cleared
MTIE Within Threshold
FFOFF Within Threshold
097-58001-01 Revision E – September 2006