Symmetricom TimeProvider 1100 Reference Manual page 47

Table 2-5. ED-EQPT – Keywords and Values (Continued)
<keyword> <value>
BAUD 2400
9600
19200
28800
38400
57600
FLOW NONE
SW
HW
SWHW
Note: For valid IP address ranges, refer to RFC1466 and RFC3330.
Note: To avoid unexpected interruptions in NTP service, you must restart the IMC card after you
change either the Subnet Mask or the IP Address when NTP is active.
IPGATE IP dot
notation
IPADDR IP dot
notation
IPSUBNET IP dot
notation
IPHOST (1, 2, 3,
4)
ACTIVE
IOCMODE
STANDBY The specified IOC card is forced to the standby state. The
097-58001-01 Revision E – September 2006
Description
<aid> = COML | COMR only
The specified serial port's baud rate is set to 2400 baud.
The specified serial port's baud rate is set to 9600 baud.
The specified serial port's baud rate is set to 19200 baud.
The specified serial port's baud rate is set to 28800 baud.
The specified serial port's baud rate is set to 38400 baud.
The specified serial port's baud rate is set to 57600 baud.
No flow control is set on the port.
Software flow control (XON/XOFF) is set on the specified
port.
Hardware flow control (CTS/RTS) is set on the specified
port.
Both software and hardware flow control is set on the
specified port.
<aid> = COMI only
The IP address of the default gateway.
The range is 1.0.0.1 to 254.255.255.254
The IP address of the Network Element.
The range is 1.0.0.1 to 254.255.255.254
The subnet mask.
The range is 1.0.0.1 to 255.255.255.254
Reserved for future use.
<aid> = IOCm
The specified IOC card is forced to the active state. The
other IOC card is set to the standby state.
other IOC card is set to the active state.
Note: If only one IOC card is installed, the
IOCMODE=STANDBY setting is ignored.
Chapter 2 TL1 Command Syntax and Description
Edit Equipment (ED-EQPT)
TimeProvider TL1 Reference Guide
Default
9600
NONE
127.0.0.1
127.0.0.1
255.255.
255.0
ACTIVE
47