Symmetricom TimeProvider 1100 Reference Manual page 165

Table C-1. Event Identifiers (Continued)
Event ID
or Event Description
CONDTYPE
SSMBIT Allows the user to
provision E1 bit position
and generate SSMs on
the specified bit position.
CRC must be enabled to
allow SSM generation.
CKTIDCHG A user has modified the
Circuit ID for the output.
FRMTYPE Allows the user to
provision the type of input
framing or the input
frequency.
Allows the user to
provision the output
framing type.
FREEFLT Defines if the output fault
is set or not set when the
LO enters Free-run mode
of operation. The output
groups are provisioned
for fault strategies.
HOLDFLT Defines if the output fault
are set or not set when
the LO enters Holdover
mode of operation. The
output groups are
provisioned for fault
strategies.
OUTSTATE The specified output
state has changed
AUTHEN Allows the user to enable
or disable NTP
Authentication. This
parameter applies to both
Server and Peer.
097-58001-01 Revision E – September 2006
AID
Default Value
TYPE
T1 ALL
EIA-422 Output Event Codes
T1 GPS
T1 OUTPUT =
1.544M
T1 SQUELCH
T1 ON
T1 DISABLE
NTP Event Codes
EQPT DISABLE
Appendix C Events
Value Description
4 | 5 | 6 | 7 | 8 | ALL
The ID can be up to 40 characters
in length.
1.544M – 1.544 MHz
2M – 2.048 MHz
ON – In fault mode generate
outputs based upon system
SSM
AIS – In fault mode generate
AIS outputs
SQUELCH – In fault mode
outputs are turned off
ON – In fault mode generate
outputs based upon system
SSM
AIS – In fault mode generate
AIS outputs
SQUELCH – In fault mode
outputs are turned off
ENABLE – Enable the output
to generate the defined signal
type
DISABLE – Disable the output
ENABLE – NTP
Authentication is enabled
DISABLE – NTP
Authentication is disabled
TimeProvider TL1 Reference Guide 165