Lldp-Med Network Policy - NETGEAR XS708T User Manual

XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
• To configure all interfaces with the same settings, select the check box in the heading
row.
7. Use the following menus to configure the LLDP settings for the selected ports:
• Admin Status. Select the status for transmitting and receiving LLDP packets:
- Tx Only. Enable only transmitting LLDP PDUs on the selected ports.
- Rx Only. Enable only receiving LLDP PDUs on the selected ports.
- Tx and Rx. Enable both transmitting and receiving LLDP PDUs on the selected
ports.
- Disabled. Do not transmit or receive LLDP PDUs on the selected ports.
The default is Tx and Rx.
• Management IP Address. Choose whether to advertise the management IP address
from the interface. The possible field values are as follows:
- Stop Advertise. Do not advertise the management IP address from the interface.
- Auto Advertise. Advertise the current IP address of the device as the
management IP address.
The default is Auto Advertise.
• Notification. When notifications are enabled, LLDP interacts with the trap manager to
notify subscribers of remote data change statistics. The default is Disable.
• Optional TLV(s). Enable or disable the transmission of optional type-length value
(TLV) information from the interface. The default is Enable. The TLV information
includes the system name, system description, system capabilities, and port
description.
For information about how to configure the system name, see
Switch Management Settings
port description, see
8. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.

LLDP-MED Network Policy

This page displays information about the LLPD-MED network policy TLV transmitted in the
LLDP frames on the selected local interface.

To view LLDP-MED network policy information for an interface:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
on page 30. For information about how to configure the
Configure Port Settings
Configure System Information
85
View and Configure the
on page 117.