NETGEAR XS708T User Manual page 101

XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
6. Next to DHCP Snooping Mode, select the Enable radio button.
7. To enable the verification of the sender's MAC address for DHCP snooping, next to MAC
Address Validation, select the Enable radio button.
When MAC address validation is enabled, the device checks packets that are received on
an untrusted interface to verify that the MAC address and the DHCP client hardware
address match. If the addresses do not match, the device drops the packet.
8. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Enable DHCP for All Interfaces in a VLAN

To enable DHCP snooping for all interfaces that are members of a VLAN:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 10.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select System> Services > DHCP Snooping > Global Configuration.
The DHCP Snooping Global Configuration page displays.
6. In the VLAN ID field, specify the VLAN on which DHCP snooping is enabled.
7. From the DHCP Snooping Mode menu, select Enable.
8. Click the Apply button.
Configure System Information
101
Change the Default IP Address of the