NETGEAR XS708T User Manual page 384

XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
9. Use one of the following methods to narrow down the ports that are displayed:
• Select Unit ID to display the physical ports of the selected unit.
• Select LAG to display a list of LAGs only.
• Select CPU to display a list of CPUs only.
• Select All to display a list of all physical ports, LAGs, CPUs, and VLANs.
10. Use one of the following methods to select one or more source ports:
• Select a specific interface by specifying the interface number using the respective
naming convention (for example, xg1 or l1) in the Go To Interface field and clicking
the Go button. See
The entry corresponding to the specified interface is selected.
• Select one or more check boxes in the Interface column.
Traffic from the selected ports is sent to the probe port.
11. From the Direction menu, specify the direction of the traffic that must be mirrored from the
selected source ports:
• None. The value is not configured. This is the default setting.
• Tx and Rx. Monitors transmitted and received packets.
• Rx. Monitors received (ingress) packets only.
• Tx. Monitors transmitted (egress) packets only.
12. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The Status field indicates the interface status.
Interface Naming Conventions
Monitor the System
384
on page 21 for more information.