NETGEAR XS708T User Manual page 405

XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual

To send an IPv4 traceroute:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 10.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Maintenance > Troubleshooting > Traceroute IPv4.
6. In the IP Address/Hostname field, enter the IP address or host name of the device for
which the path must be discovered.
7. In the Probes Per Hop field, enter the number of probes per hop.
The default value is 3. The range is 1 to 10.
8. In the Max TTL field, enter the maximum time to live (TTL) for the destination.
The default value is 30. The range is 1 to 255.
9. In the Init TTL field, enter the initial TTL to be used.
The default value is 1. The range is 1 to 255.
10. In the MaxFail field, enter the maximum number of failures allowed in the session.
The default value is 5. The range is 1 to 255.
Change the Default IP Address of the
Maintenance
405