Configure Dual Image Settings - NETGEAR XS708T User Manual

XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
6. Next to Source Image, select the image1 or image2 radio button to specify the image to be
copied.
7. Next to Destination Image, select the image1 or image2 radio button to specify the
destination image.
8. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.

Configure Dual Image Settings

The Dual Image feature allows the switch to retain two images in permanent storage. Use the
Dual Image Configuration page to select which image to load during the next boot cycle,
configure an image description, or delete an image. This feature reduces switch down time
when you are upgrading or downgrading the software image.
Change the Image That Loads During the Boot Process

To change the image that loads during the boot process:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 10.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Maintenance > File Management > Dual Image Configuration.
Change the Default IP Address of the
Maintenance
398