Configure Garp Switch Settings - NETGEAR XS708T User Manual
8-port, 12-port, and 16-port
10-gigabit smart managed pro switch
Hide thumbs
Also See for XS708T:
- Hardware installation manual (32 pages) ,
- Installation manual (2 pages) ,
- Installation (2 pages)
Table of Contents
Advertisement
XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual
Note:
Authentication through dot1x is possible only if dot1x is enabled.
12.
In the DSCP Value field, configure the Voice VLAN DSCP value for the port.
The valid range is 0 to 64. The default value is 0.
The Operational State field displays the operational status of the voice VLAN on the given
interface.
13.
Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Configure GARP Switch Settings
The Generic Attribute Registration Protocol (GARP) is used to exchange information
between GARP participants to register and deregister attribute values within a bridged LAN.
When a GARP participant declares or withdraws a given attribute, the attribute value is
recorded with the applicant state machine for that attribute, for the port from which the
declaration or withdrawal was made.
•
Registration occurs only on ports that receive the GARP PDU containing a declaration or
withdrawal.
•
Deregistration occurs only if all GARP participants connected to the same LAN segment
as the port withdraw the declaration.
GARP is part of the IEEE 802.1p extension to its 802.1D (spanning tree) specification. It
includes the following:
•
GARP Information Declaration (GID). The part of GARP that generates data.
•
GARP Information Propagation (GIP). The part of GARP that distributes data.
Note:
It can take up to 10 seconds for GARP configuration changes to take
effect.
To configure GARP switch settings:
1.
Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2.
Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch
on page 10.
The login window opens.
Change the Default IP Address of the
Configure Switching
139
Hide quick links:
Advertisement
Table of Contents
