B6: Dwell Function; B7: Droop Control - YASKAWA A1000 HHP Programming Manual

No.
(Addr. Name
Hex)
b5-39
PID Setpoint Display Digits
(1FF)
b5-40 Frequency Reference
(17F) Monitor Content during PID
<1> Default setting is determined by parameter A1-02, Control Method Selection.
<2> Default setting is dependent on parameter b5-20, PID Setpoint Scaling.
u

b6: Dwell Function

No.
(Addr. Name
Hex)
b6-01
Dwell Reference at Start
(1B6)
b6-02
Dwell Time at Start
(1B7)
b6-03
Dwell Reference at Stop
(1B8)
b6-04
Dwell Time at Stop
(1B9)
u

b7: Droop Control

No.
(Addr. Name
Hex)
b7-01
(1CA)
Droop Control Gain
b7-02
(1CB)
Droop Control Delay Time
b7-03 Droop Control Limit
(17E) Selection
YASKAWA ELECTRIC SIEP YEAHHP 01B YASKAWA AC Drive – A1000 HHP Programming Manual
Description
All Modes
0: No decimal places
1: One decimal place
2: Two decimal places
3: Three decimal places
All Modes
0: Display the frequency reference (U1-01) after PID compensation has been
added.
1: Display the frequency reference (U1-01) before PID compensation has been
added.
Description
All Modes
Parameters b6-01 and b6-02 set the frequency to hold and the time to maintain
that frequency at start.
All Modes
Parameters b6-03 and b6-04 set the frequency to hold and the time to maintain
that frequency at stop.
Description
V/f V/f w PG OLV
OLV/PM AOLV/PM CLV/PM
Sets the speed reduction gain applied at a torque reference of 100%. Set as a
percentage of motor base speed.
V/f V/f w PG OLV
OLV/PM AOLV/PM CLV/PM
Adjusts the responsiveness of Droop Control.
V/f V/f w PG OLV
OLV/PM AOLV/PM CLV/PM
0: Disabled
1: Enabled
CLV
CLV
CLV
A.4 b: Application
Values Page
<2>
Default:
42
Range: 0 to 3
Default: 0
42
Range: 0, 1
Values Page
Default: 0.0 Hz
Min.: 0.0 43
Max.: 400.0
Default: 0.0 s
Min.: 0.0 43
Max.: 10.0
Default: 0.0 Hz
Min.: 0.0 43
Max.: 400.0
Default: 0.0 s
Min.: 0.0 43
Max.: 10.0
Values Page
Default: 0.0%
Min.: 0.0 44
Max.: 100.0
Default: 0.05 s
Min.: 0.03 44
Max.: 2.00
Default: 1
44
Range: 0, 1
245
A