System; Network - Fujitsu ETERNUS CS800 S5 User Manual

System

System
The System page allows you to configure system settings for the ETERNUS CS800,
including network settings, system date and time, and security settings.
To access the System page, click the Configuration menu, and then click the System tab.
The System page contains the following tabs:

"Network"

●
"Date & Time"
●
"Security"
●
Network
The Network page allows you to view and change network configuration information for the
ETERNUS CS800. The ETERNUS CS800 uses this information to connect to the network.
Network configuration information is entered during initial setup ETERNUS CS800. You
should consult your network administrator before making any changes to the network
settings.
V
I
To access the Network page, on the System page, click the Network tab (see
286
CAUTION!
Changing the network configuration requires a system reboot to allow all system
services to function correctly. Changing the network configuration requires a system
reboot immediately after the changes are applied.
Rebooting the system can take several minutes. After the new network
configuration is saved, close your Web browser and wait 15 minutes before logging
in again. If you change the IP address that you use to log in to the system, you will
temporarily lose your connection to the remote management console. Because of
this, you might not see a confirmation page informing you that the new settings have
been saved.
Configuration
Figure 177).
U41840-J-Z125-7-76