Configuration Wizards
●
●
●
●
2. Click Add.
3. (Optional) To add additional partitions, repeat Steps 1–2.
4. Click Next to continue.
U41840-J-Z125-7-76
ADIC Pathlight VX
●
Number of Storage Slots - Accept the default number of storage slots (based on
system model), or enter the number of storage slots in the partition (up to 9,000).
I
One I/E slot is created for each storage slot up to a maximum of 240 I/E
slots.
Virtual Tape Drive Model - Select the tape drive model emulated by the virtual
drives in the partition. All virtual tape drives in a partition must be the same model.
The following tape drive models are available:
IBM LTO-1, LTO-2, LTO-3, LTO-4, or LTO-5
●
HP LTO-1, LTO-2, LTO-3, LTO-4, or LTO-5
●
Number of Virtual Tape Drives - Accept the default number of tape drives (based
on system model), or enter the number of virtual tape drives in the partition.
I
If all tape drives are currently assigned to other partitions, you must remove
one or more tape drives from an existing partition to make them available
for use in a new partition.
Enable deduplication - Select the check box to enable data deduplication. Fujitsu
Technology Solutions recommends that you enable data deduplication to optimize
disk usage.
I
Data deduplication is enabled by default. You cannot enable or disable data
deduplication after the partition is added.
VTL Wizard
147