Modules With Electrostatic-Sensitive Devices; Notes On Cleaning The Devices - Fujitsu ETERNUS CS800 S5 User Manual

Important Information

Modules with Electrostatic-Sensitive Devices

Modules with electrostatic-sensitive devices are identified by the following sticker:
Figure 1: ESD label
When you handle components fitted with ESDs, you must always observe the following
points:
Switch off the system and remove the power plugs from the power outlets before
●
installing or removing components with ESDs.
You must always discharge static build-up (e.g. by touching a grounded object) before
●
working with such components.
Any devices or tools that are used must be free of electrostatic charge.
●
Wear a suitable grounding cable that connects you to the external chassis of the system
●
unit.
Always hold components with ESDs at the edges or at the points marked green (touch
●
points).
Do not touch any connectors or conduction paths on an ESD.
●
Place all the components on a pad which is free of electrostatic charge.
●
I

Notes on Cleaning the Devices

V
U41840-J-Z125-7-76
For a detailed description of how to handle ESD components, see the relevant
European or international standards (EN 61340-5-1, ANSI/ESD S20.20).
CAUTION!
Switch the device off and disconnect the power plugs from the grounded shock-
●
proof sockets.
Do not clean any interior parts yourself; leave this job to a service technician.
●
Do not use any cleaning agents that contain abrasives or may corrode plastic.
●
Safety Instructions
23