Step 1: About; Step 2: System - Fujitsu ETERNUS CS800 S5 User Manual

Configuration Wizards

Step 1: About

1. Read the information about the wizard (see
2. Click Next to continue.
I
Figure 104: Replication Wizard

Step 2: System

1. If data on this ETERNUS CS800 will be replicated to another system, enter the following
information under Target System (see
a) In the Target Hostname or IP Address box, enter the hostname or IP address of
b) (Optional) Select the Encrypt data before replication check box selected to
U41840-J-Z125-7-76
At any time while using the wizard, you can click Previous to return to the previous
step.
I
If two targets are already specified, you must delete a target before adding
another. First click Pause to pause replication to the target, and then click
Delete to remove the target.
the system that will receive the replicated data.
I
When entering IP addresses, never use an address that is in a reserved IP
address range. To see a list of reserved IP address ranges, click the quick
tip icon [?] located near the IP address field.
I
To use hostname format, you must specify at least one DNS IP address on
the Network page (see
enable encryption when sending replication data to the target system. Or clear the
Encrypt data before replication check box to disable encryption when sending
Figure 104).
Figure 105). You can specify up to two targets:
"Network" on page 286).
Replication Wizard
161