VTL
Click Hide I/E Slots or Show I/E Slots to hide or show the virtual I/E slots in the VTL
●
(see
Tape Drives
The Tape Drives section displays information about virtual tape drives in the VTL:
If a cartridge is mounted in the tape drive, the barcode of the cartridge displays beneath
●
the drive.
Click a tape drive to view detailed information about the drive.
●
Storage and I/E Slots
The Storage Slots and I/E Slots sections displays information about the virtual cartridges
located in the storage and I/E slots:
The following information is displayed for each cartridge:
●
●
●
●
●
●
●
V
Click a cartridge to view detailed information about the cartridge.
●
When the storage system is degraded, all tape cartridges are shown in a degraded
●
state.
When the storage system has failed or is inaccessible due to failure, all tape cartridges
●
are shown as unavailable.
Logical View
Use the Logical View page to view information about the virtual (logical) components in a
VTL partition. You can also view information about used space in the partition.
410
"Storage and I/E Slots" on page
Slot - The slot where the cartridge is located.
Barcode - The barcode of the cartridge.
WP - The write protect status of the cartridge.
Capacity - The capacity of the cartridge.
Used - The amount of space on the cartridge currently used to store data.
Used Percent - The amount of currently used space on the cartridge expressed as
a percentage of the total capacity ([Used / Capacity] x 100).
CAUTION!
The Used (%) value is not updated while the media is mounted. Because of this,
the displayed Used (%) value may be different from the real value for mounted
media.
410).
Status
U41840-J-Z125-7-76