Fujitsu ETERNUS CS800 S5 User Manual page 476

ETERNUS CS800 S4/S5 Hardware
2.5-inch HDD Module
Figure 294: 2.5-inch HDD Module
1 Installation frame with hard disk drive installed
2 Indicators
HDD Busy (LED green)
HDD Fault (LED orange)
For description see section
3 Handle for locking and unlocking the HDD module
4 Button for locking and unlocking the handle
Handling Hard Disk Drives and HDD Modules
Hard disk drives incorporated in the HDD modules are highly sensitive electromagnetic
devices and must be handled with great care. Incorrect handling can cause partial or total
failure of the hard disk drives. These failures can result in data errors and to a loss of data
or to total corruption of the hard disk drive.
Observe the following rules to prevent such problems occurring:
Only store and transport HDD modules within the limits stipulated in the specification.
●
When transporting HDD modules (even over short distances), always use the original
●
packaging (ESD label).
Never expose HDD modules to a temperature shock. Avoid the formation of conden-
●
sation inside and on the outside of the hard disk drive.
V
508
1 2 3 4
"Hard Drive Carrier Indicators" on page
CAUTION!
The HDD module must be acclimatized in its operating environment for an accli-
matization time before it is started up for the first time.
Removal and Replacement Procedures for CRUs
73.
U41840-J-Z125-7-76