Table of Contents
Advertisement
Notifications
IP Address / Network Mask
10.40.166.87
255.255.255.255
10.40.166.87
10.40.166.87
10.40.166.87
10.40.166.0
10.40.166.87
255.255.0.0
10.40.0.0
255.255.0.0
I
I
4. In the Access Type drop-down box, select the access type for the community:
●
●
5. Select the Community status check box to enable the community.
Or clear the Community status check box to disable the community.
6. Click Apply.
Editing a Community
Edit an SNMP community to change the IP address or access type for the community. You
can also enable or disable the community.
To edit a community:
1. Click Edit.
The Edit SNMP Community page displays (see
328
If you define a single community and set both the IP address and network mask
to 0.0.0.0 (or leave both blank), then IP address-based access control is
disabled. In this case, the SNMP agent is accessible from any IP address.
When entering IP addresses, never use an address that is in a reserved IP
address range. To see a list of reserved IP address ranges, click the quick tip
icon [?] located near the IP address field.
Get - Allows SNMP get operations.
Get/Set - Allows both SNMP get and put operations.
Result
Allows access only from
10.40.166.87
Allows access only from
10.40.166.87
Invalid because the logical
bitwise operation (address AND
mask) is not equal to the address
Invalid because the logical
bitwise operation (address AND
mask) is not equal to the address
Allows access from any client
with address 10.40.xx.xx
Figure
Configuration
204).
U41840-J-Z125-7-76
Hide quick links:
Advertisement
Table of Contents
