Fujitsu ETERNUS CS800 S5 User Manual page 483

Removal and Replacement Procedures for CRUs
Figure 302: Removing a 3.5-inch HDD module
2. While pressing down on the locking button (1) fold up the lever (2).
I
3. Wait about 30 seconds to allow the hard disk drive to spin down.
4. Pull the HDD module completely out of its bay.
U41840-J-Z125-7-76
Thereby, the HDD module is pushed out of its drive bay by about 1 cm and
disconnected from the SAS / SATA backplane.
ETERNUS CS800 S4/S5 Hardware
515