Configuration
Figure 205: SNMP Test Page
To send a test SNMP trap, select a destination in the list and click Send. If the destination
does not receive the SNMP trap, make sure that the destination IP address is correct (see
"Editing a Destination" on page
correct (see
AIS Connect
AIS (Advanced Infrastructure Solutions) Connect has the following functions:
Call-home - Provides system monitoring: Service tickets which indicate hardware
●
failures are automatically sent to the Fujitsu Service Centre.
Dial-in - Provides remote access: Allows Fujitsu support specialists to remotely connect
●
to the system. Remote access is only possible if it has been enabled on the ETERNUS
CS800 system.
The setup of AISConnect consists of two tasks:
Configuring and enabling the AISConnect service on the ETERNUS CS800 system,
●
which is described below.
Registering the ETERNUS CS800 system with the Fujitsu Service Centre.
●
U41840-J-Z125-7-76
324). Also make sure that the community information is
"Community" on page
325).
Notifications
331