Fujitsu ETERNUS CS800 S5 User Manual page 128

Running the Getting Started Wizard
3. Click Update to save the changes you made to the Bonding Details table. (Clicking
Update does not yet apply the new network settings to the ETERNUS CS800.)
Click Undo to revert to all current Bonding Details changes to the last update.
Configuring Interface Details
Under IP Address Configuration > Interface Details, configure VLAN tagging and jumbo
Ethernet frame settings for each port or device (see
Figure 72: Network Page: Interface Details
1. If necessary, click the Show link to show the interface details table.
2. For each device, select the check box to enable VLAN tagging for the device. (Or clear
the check box to disable VLAN tagging for the device.)
VLAN tagging allows you to assign a device to a virtual local area network (VLAN). With
VLAN tagging, you can route different traffic types (management, data, and replication)
over different VLANs, making sure traffic types do not mix.
If VLAN tagging is enabled, enter the VLAN Tag ID for the device. (Valid values are 2
to 4094. You can assign only one tag ID to an device.)
I
V
114
another port becomes active to take its place. Because only the MAC address of
the active port is visible to the Ethernet switch, the switch does not require
additional configuration.
To maintain connectivity, the switch ports connected to the ETERNUS CS800
must be configured to accept the correct VLAN tag ID.
CAUTION!
If VLAN tagging is enabled for a device, ETERNUS CS800 Advanced Reporting
is unable to collect and record statistics for traffic moving over the VLAN device
(for example, eth1.400). Statistics are still collected for the base device (for
example, eth1.)
Initial Configuration, Connecting with the Network
Figure 72):
U41840-J-Z125-7-76