Fujitsu ETERNUS CS800 S5 User Manual page 479

Removal and Replacement Procedures for CRUs
Figure 298: Removing a 2.5-inch HDD
Installing a 2.5-inch HDD
1. Unlock the HDD module as described above.
2. Insert the HDD module into a drive bay and carefully push back as far as it will go (1).
3. Close the locking lever to lock the hard disk drive in place (2).
4. If the status of the HDD remains "unknown" after rebuild has finished, contact Fujitsu
Customer Support (see
U41840-J-Z125-7-76
"Support and Help" on page
ETERNUS CS800 S4/S5 Hardware
18).
511