Fujitsu ETERNUS CS800 S5 User Manual page 311

Configuration
Using the data interface, the ETERNUS CS800 needs to connect to a backup host that
●
is on the 10.50.50.x subnet. Because this host is not on the same subnet as the data
interface, the ETERNUS CS800 cannot communicate with the host unless you specify
routing information in the Routing Details section.
In this example, you would specify 10.50.50.0 for destination network, 255.255.255.0
for the destination netmask, and 10.20.20.1 as the destination gateway.
I
Corporate Network
Default Gateway
10.30.24.1
Figure 183: Interface Routing: Example 1
Example 2: Segments on the Same Subnet and Target on a Different Subnet
In the example below (see
faces, one for data and management traffic, and one for replication traffic:
The source ETERNUS CS800 management/data IP address and the source
●
ETERNUS CS800 replication IP address are on the same subnet (192.168.10.x). The
target ETERNUS CS800 IP address is on a different subnet (192.168.20.x)
U41840-J-Z125-7-76
The gateway specified in the IP Address Table section is for incoming traffic to the
interface. The gateway specified in the Routing Details section is for outgoing traffic
from the interface.
10.30.24.x subnet
Figure
10.50.50.x subnet
10.20.20.x subnet
10.40.40.x subnet
184), the ETERNUS CS800 has two segmented inter-
System
Host or Client
10.50.50.1 gateway
10.20.20.1 gateway
10.40.40.1 gateway
Host or Client
297