Fujitsu ETERNUS CS800 S5 User Manual page 473

Removal and Replacement Procedures for CRUs
Figure 291: Installing the PSU
●
●
V
●
Connecting the server to the mains
In its basic configuration level the server has a hot-plug power supply unit. A second hot-
plug power supply unit can be added to ensure a redundant power supply. If one power
supply unit is defective, the other then guarantees unimpaired operation. Each hot-plug
power supply unit can be replaced during operation
V
U41840-J-Z125-7-76
Insert the PSU module into its slot.
Push the PSU module into its slot (1) as far as it will go until the locking latch snaps
in place (2).
CAUTION!
Ensure that the PSU module properly engages in its slot and is locked in
position in order to prevent it from sliding out of the chassis during
transportation.
If applicable, fold down the handle on the PSU module (3).
CAUTION!
The server is automatically set to a mains voltage in the range 100 V - 240 V. You
may only operate the server if its rated voltage range corresponds to the local mains
voltage.
ETERNUS CS800 S4/S5 Hardware
505