Fujitsu ETERNUS CS800 S5 User Manual page 129

Initial Configuration, Connecting with the Network
3. For each device, select the MTU (Maximum Transmission Unit) frame size in the
Jumbo Frame MTU Size drop-down box.
●
4. Click Update to save the changes you made to the Interface Details table. (Clicking
Update does not yet apply the new network settings to the ETERNUS CS800.)
Click Undo to revert to all current Interface Details changes to the last update.
Configuring Interface IP Addresses
Under IP Address Configuration > IP Address Table, configure one or more network
interfaces for each port or device (physical Ethernet port or bonded device) (see
Figure 73: Network Page: IP Address Table
1. Click the Add IP link to add a network interface to a device.
Or select an interface to edit the IP address, netmask, gateway and traffic type. To
select an interface, click the radio button next to the interface index name, for example,
bond0:2.
I
U41840-J-Z125-7-76
1500 MTU - The standard (STD) MTU frame size of 1,500 bytes is used.
9000 MTU - The jumbo MTU frame size of 9,000 bytes is used.
I
Jumbo frames can only be used, if all devices in the particular network
(client side ethernet controller, switches, router) support Jumbo frames.
A maximum of 10 IP addresses are allowed per device. All IP addresses in the
IP Address Table (added or modified) must be valid and unique, and must have
a valid gateway and netmask.
Running the Getting Started Wizard
Figure 73):
115