....................................................................................................................................................................................................................................

Overview

Before you begin

Procedure

365-374-059

Issue a, January 2002

This section provides a procedure for setting up the NE date and time.

NOTE: The NE clock must be set again after each power on or

reboot!

Prior to performing this task, you must be logged into the WaveStar

CIT and the respective NE.

Required privilege code(s)

You must have at least a privilege code of P3, Provisioning, or M3,

Maintenance, to set the system parameters.

Required equipment

The following equipment is required to perform this task:

•

WaveStar CIT.

Complete the following steps to set the date and time of the

system:

............................................................................................................................................................

In the WaveStar CIT

Provision

Result:

The window

Equipment

side of the window.

Alternatively you can also right-click on the white area of the window

and select

Provision System...

............................................................................................................................................................

Select the system in the

Result:

The selection window for the system parameters appears on the

right side of the window.

............................................................................................................................................................

Select the

Date and Time

Lucent Technologies

, select

System View

Provision Parameters for Protection Groups or

opens. The

selection tab appears on the left

Equip

. Proceed with Step 3.

Equip

selection tab and click on