Table of Contents
Advertisement
Connecting the WaveStar
....................................................................................................................................................................................................................................
Overview
Direct LAN access
(point-to-point)
WaveStar CIT LAN access
(network)
....................................................................................................................................................................................................................................
5 - 1 6
®
CIT to the NE
The WaveStar CIT can be connected to a network element in 3
different ways:
•
Direct LAN Access (point-to-point)
•
LAN Access (network)
•
Remote Access via DCC.
The WaveStar CIT (LAN card) is connected to the LambdaUnite
MultiService Switch (MSS) via the "CIT" port of the user panel or
through a backplane connector (LAN I/O Panel). An unshielded
crossed Ethernet LAN cable (100BaseT) with 4-wire RJ-45 connectors
is used for this connection.
The usage of shielded 100BaseT LAN cables is only allowed if the
applicable national safety requirements have been met by the user.
Otherwise, there is a risk of electrical shock and/or serious injury.
The following figure illustrates the Direct LAN Access
(Point-to-Point).
User Panel
PWR ON
CR
MJ
MN
CIT (LAN)
ABN
WaveStar CIT access to more than one NE, e.g. within one site, can
be done via a Local Area Network (LAN). The LAN is connected to
the NEs by means of 100-BaseT Ethernet interfaces on 4-wire RJ-45
connectors (a crossed LAN cable must be used!).
Lucent Technologies
NE ACTY
FE ACTY
ACO
LED TEST
Commissioning
™
®
WaveStar CIT
365-374-059
Issue a, January 2002
Advertisement
Table of Contents
