Installing the WaveStar
....................................................................................................................................................................................................................................
Purpose
Required equipment
Before you begin
....................................................................................................................................................................................................................................
5 - 6
®
CIT
Use this procedure to:
•
Install the WaveStar CIT software onto a new system.
•
Upgrade/change an existing WaveStar CIT to a new software
version.
The minimum requirements for a WaveStar CIT are a personal
computer with:
•
®
Pentium
266 MHz processor (Pentium III 500 MHz or higher
recommended) with 128 MB of RAM (256 MB of RAM or
higher recommended)
•
150 MB of free hard-disk drive space
•
CD-ROM drive (16X recommended)
•
™
CompactFlash
•
SVGA monitor set to 800x600 resolution or greater, with 256
colors (1024x768, 16 million colors recommended)
•
100BaseT LAN interface, installed and working
•
Unshielded crossed Ethernet LAN cable with 4-wire RJ-45
connectors
•
®
Microsoft
Windows NT
®
Windows
2000 operating system
•
®
®
Adobe
Acrobat
•
Removable hard-disk drive (optional; required only for system
backup).
The performance of the user interface can be enhanced by using a
higher performance personal computer.
A user who has Windows NT / Windows 2000 System Administration
privileges must install the software. That same user, then, becomes the
WaveStar CIT System Administrator. The WaveStar CIT System
Lucent Technologies
card
®
4.0 with Service Pack 5 or Microsoft
®
Reader
for Windows (version 3.01 or later)
Commissioning
365-374-059
Issue a, January 2002