....................................................................................................................................................................................................................................

Procedure

3 - 5 2

............................................................................................................................................................

Temporarily remove the mounting brackets ( Bracket, Front-left, Unite

— DC1003774 Item 1) and ( Bracket, Front-right,Unite —

DC1003775 Item 2); from the subrack.

............................................................................................................................................................

Mount the Fiber Clip — DC1000680 (Item 5) on the front

mounting-brackets.

............................................................................................................................................................

When a second subrack is mounted in the configuration of one

™

LambdaUnite

rack frame, temporarily remove the Rubber Profile —

DC1003971 (Item 6) at the front-top of the bottom subrack and at

both front-top sides.

..........................................................................................................................................................

Slide the subrack at the rear into its configuration position in the

Unite rack.

If subrack is located in

the

Upper position in the

Unite rack

Lower position in the

Unite rack

............................................................................................................................................................

Mount the subrack on the center style at the rear by using Screw,

Tapping Thread-Forming, M6x16 — CC901331421 with 7 Nm±1.0

torque .

............................................................................................................................................................

Where two subracks are mounted in one Unite rack-frame attach the

Rubber Profile — DC1003971 (item 6) at the front-top of the bottom

subrack and at both front-top sides.

............................................................................................................................................................

Mount the mounting brackets ( Bracket, Front-left, Unite —

DC1003774 Item 1) and ( Bracket, Front-right,Unite — DC1003775

Lucent Technologies

Then

Use the Subrack Guide — DC1002905

which is mounted at hole 38 on the

center style of the Unite rack-frame.

Use the bottom of the Unite rack-frame

as guide.

Equipment Installation

365-374-059

Issue a, January 2002