Lucent Technologies LambdaUnite Installation Manual page 229

Provisioning the System Parameters
....................................................................................................................................................................................................................................
365-374-059
Issue a, January 2002
IF
you want to change the
default interface standard
to SONET,
you want to change the
default interface standard
to SDH,
you want a fixed tributary
rate list,
you want the tributary
signal rate list to adapt,
you want that the system
synchronization is in SDH
characteristics,
you want that the system
synchronization is in
SONET characteristics,
............................................................................................................................................................
Click the Apply
4
Result:
The LambdaUnite
As a consequence, the management association between the
WaveStar CIT and the NE will be lost.
After the system reset has finished, you can re-establish the
management association by again connecting the WaveStar CIT
to the NE.
............................................................................................................................................................
Confirm the resulting system message by clicking
5
E S
N D O F T E P S
............................................................................................................................................................
Lucent Technologies
THEN
set the Optical Interface Standard
SONET .
set the
Optical Interface Standard
. This is the default value.
SDH
set the
Tributary Mode Default
Fixed-Rate
set the Tributary Mode Default
Adaptive-Rate
set the System Synch Characteristics
SDH . This is the default value.
set the
System Synch Characteristics
.
SONET
pushbutton.
™
MSS NE will now perform a system reset.
Commissioning
to
.
to
.
.
OK
to
to
to
to
5 - 2 5