Table of Contents
Advertisement
Modular Plug Connector
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
A - 4
............................................................................................................................................................
1
Strip the cable jacket 35 mm.
Important! Make sure not to cut the cable shield.
............................................................................................................................................................
Fold the cable shield back over the cable jacket. Bend the drain wire
2
back across center of the cable shield on external conductive side.
Strip the shield for each pair maintaining 5.0 mm shield from the
jacket end.
............................................................................................................................................................
Slide the connector shield onto the cable shield. If the cable diameter
3
is close to 6.0 mm it may be necessary to rotate the connector shield
as it passes over the cable shield. Cut and remove the plastic wrap if
any.
Important! Make sure not to exceed the cable shield length.
............................................................................................................................................................
Arrange the conductors.
4
•
Untwist conductors and orient them according to the next table
(cross conductor 6 over conductors 4 & 5).
•
Trim the conductor ends. This makes insertion into the wire
holder easy.
Slide the conductors into the wire holder. Use the floor of the wire
holder to bring the conductor ends into the same plane.
Important! The wire holder should be fully slid down onto the
twisted conductors until the conductors resistance impede to continue.
............................................................................................................................................................
5
Turn the subassembly (housing + contacts) over to aid trimming.
............................................................................................................................................................
Trim the conductors using the front edge of the wire holder as a
6
guide.
............................................................................................................................................................
Turn the subassembly over to aid insertion.
7
Lucent Technologies
Assembly Instructions
365-374-059
Issue a, January 2002
Advertisement
Table of Contents
