Table of Contents
Advertisement
®
WaveStar
CIT
Connecting the WaveStar
....................................................................................................................................................................................................................................
Overview
Direct LAN access
(point-to-point)
WaveStar CIT LAN access
(network)
....................................................................................................................................................................................................................................
365-374-074
Issue a, April 2002
®
CIT to the NE
The WaveStar CIT can be connected to a network element in 3
different ways:
•
Direct LAN Access (point-to-point)
•
LAN Access (network)
•
Remote Access via DCC.
The WaveStar CIT (LAN card) is connected to the LambdaUnite
MultiService Switch (MSS) via the "CIT" port of the user panel or
through a backplane connector (LAN I/O Panel). An unshielded
LAN cable CAT5 with 4-wire RJ-45/RJ-45 connectors must
crossed
be used for this connection.
The usage of shielded 100BaseT LAN cables is only allowed if the
applicable national safety requirements have been met by the user.
Otherwise, there is a risk of electrical shock and/or serious injury.
The following figure illustrates the Direct LAN Access
(Point-to-Point).
User Panel
PWR ON
CR
MJ
MN
CIT (LAN)
ABN
WaveStar CIT access to more than one NE can be done via a HUB.
Unshielded
straight
LAN cables CAT5 with 4-wire RJ-45/RJ-45
connectors must be used for this connection.
Lucent Technologies
®
WaveStar
CIT installation and NE provisioning
NE ACTY
FE ACTY
ACO
LED TEST
™
®
WaveStar CIT
6 - 9
Advertisement
Table of Contents
