Using Show Commands To Verify Sip And Spa Status; Using Show Commands To Display Spa Information - Cisco uBR10012 Hardware Installation Manual

Using show Commands to Verify SIP and SPA Status

• If a SIP or SPA has not been previously installed in the same slot or subslot, then the configurations for
Using show Commands to Verify SIP and SPA Status
Use the following show commands to verify if the new SPAs are configured and operating correctly.
Procedure
Step 1 show running-config
Example:
Router#
Displays the system configuration.
The configuration should include the new SPA interfaces.
Step 2
show diag and show hw-module bay all oir
Example:
Router#
Router#
Displays all current SPAs and a summary of their status.
Should include the new SPAs and their status summary.
Step 3 show diag
Example:
Router#
Displays information about the installed SIPs.
Step 4
show version
Example:
Router#
Displays information about the installed SIPs and available interfaces.
What to Do Next
For information on commands that you can use to monitor a SIP or SPA, see the
Solution Design and Implementation Guide
Implementation

Using show Commands to Display SPA Information

Use the following show commands to view SPA information and verify its installation status.
Cisco uBR10012 Universal Broadband Router SIP and SPA Hardware Installation Guide
86
all associated interfaces remain empty.
show running-config
show diag
show hw-module bay all oir
show diag
show version
Guide.
Verifying and Troubleshooting SIPs and SPAs
and Cisco DOCSIS 3.0 Downstream Solution Design and
Cisco Cable Wideband