Cisco Catalyst 4500 Series Configuration Manual page 1214

vlan access-map
vlan access-map
To enter VLAN access-map command mode to create a VLAN access map, use the vlan access-map
command. To remove a mapping sequence or the entire map, use the no form of this command.
Syntax Description
name
seq#
Command Default This command has no default settings.
Command Modes
Global configuration mode
Command History Release
12.1(12c)EW
Usage Guidelines If you enter the sequence number of an existing map sequence, you enter VLAN access-map mode. If
you do not specify a sequence number, a number is automatically assigned. You can enter one match
clause and one action clause per map sequence. If you enter the no vlan access-map name [seq# ]
command without entering a sequence number, the whole map is removed. Once you enter VLAN
access-map mode, the following commands are available:
•
•
•
•
•
•
Examples The following example shows how to enter VLAN access-map mode:
Switch(config)# vlan access-map cisco
Switch(config-access-map)#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
2-1164
vlan access-map name [seq# ]
no vlan access-map name [seq# ]
VLAN access-map tag.
(Optional) Map sequence number; valid values are from 0 to 65535.
Modification
This command was introduced on the Catalyst 4500 series switch.
action—Sets the action to be taken (forward or drop).
default—Returns a command to its default settings.
end—Exits from configuration mode.
exit—Exits from VLAN access-map configuration mode.
match—Sets the values to match (IP address or MAC address).
no—Negates a command or reset its defaults.
Chapter 2