Register Products-Mandatory To Validate Slas; Performing An Initial Configuration Of A Qfx10000 - Juniper QFX10002 Hardware Manual

Register Products—Mandatory to Validate SLAs
Register all new Juniper Networks hardware products and changes to an existing installed product using
the Juniper Networks website to activate your hardware replacement service-level agreements (SLAs).
CAUTION: Register product serial numbers on the Juniper Networks website. Update
the installation base data if any addition or change to the installation base occurs or if
the installation base is moved. Juniper Networks is not responsible for not meeting the
hardware replacement service-level agreement for products that do not have registered
serial numbers or accurate installation base data.
Register your product(s) at
Update your installation base at
updateinstallbase.jsp.

Performing an Initial Configuration of a QFX10000

Before you begin connecting and configuring the switch, set the following parameter values on the
console server or PC:
• Baud Rate—9600
• Flow Control—None
• Data—8
• Parity—None
• Stop Bits—1
• DCD State—Disregard
You must perform the initial configuration of a QFX10000 modular switch through the console port
using the command-line interface (CLI) or through Zero Touch Provisioning (ZTP). On QFX10002 fixed-
chassis models, in addition to using the CLI, you may also use ZTP. In order to provision the QFX10002
using ZTP, you must have access to a Dynamic Host Control Protocol (DHCP) server and a File Transfer
Protocol (anonymous FTP), Hypertext Transfer Protocol (HTTP), or Trivial File Transfer Potocol (TFTP)
server on which the software image and configuration files are stored. For more information about using
ZTP for provisioning the device, see
The following procedure sets up the QFX10000 using the command-line interface (CLI).
https:/ /tools.juniper.net/svcreg/SRegSerialNum.jsp.
https:/ /www.juniper.net/customers/csc/management/
Zero Touch Provisioning Overview
.
116