Table of Contents
Advertisement
Getting Printer Information over the Network
Printer current status
You can check the printer's status using the telnet command.
❖ ❖ ❖ ❖ telnet
Use the status command.
❖ ❖ ❖ ❖ UNIX
Use the lpq or lpstat command or stat parameter of rsh, rcp, or ftp.
Reference
For more information, see "Remote Maintenance by Telnet (mshell)" in the
Network Printing Guide is provided on the CD-ROM labeled "Operating
Instructions".
Messages
Call Service Center
Cover Open: Duplex Unit
Cover Open: Front Cover
Cover Open: Mailbox
Cover Open: Paper Exit/Rear The paper exit cover or the
Cover Open: Upper Tray
Empty: Toner
Energy Saver Mode
Energy Saver Mode 1
Error: HDD Board
IEEE 802.11b Card Error
IEEE 802.11b Card or Board
Error
Error & Status Messages on the Control Panel
Description
There is a malfunction in the
printer.
The cover of the optional Du-
plex Unit is open.
Close the front cover.
The cover of the Mailbox is
open.
rear cover is open.
The upper tray cover is open.
The toner cartridge is empty.
The printer is in Energy Save
Mode.
An error has occurred in the
optional Hard Disk Drive.
The optional IEEE 802.11b
board or the optional IEEE
802.11b card is not installed.
An error has occurred in the
optional IEEE 802.11b board
or the optional IEEE 802.11b
card
Comments
Turn the printer off and on.
Close the cover of the optional
Duplex Unit.
Close the front cover.
Close the cover of the Mailbox
cover.
Close the paper exit cover or
the rear cover.
Close the upper tray cover.
Replace the new toner car-
tridge.
Wait for a while.
First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Install the optional IEEE
802.11b board or the optional
IEEE 802.11b card.
First, turn the power switch
off and then on. If the message
appears again, set the optional
IEEE 802.11b board. If the
message still appears, call
your sales or service repre-
sentative.
5
69
Advertisement
Table of Contents
