Field Service Ver. 1.0 Apr. 2007
3.5.3
Replacing the feed roller
A. Periodically replaced parts/cycle
• Feed roller: Every 150,000 prints
B. Procedure
1. Slide out the tray/1.
[2]
[1]
[2]
[2]
[1]
2. Press down the paper lifting plate.
3. Snap off the C-clip [2] from the feed
4. Slide the feed roller assy [1] to the
[1]
A09AF2C004DA
5. Loosen the set screw [1] with the
NOTE
• When reinstall the weight, tighten
A09AF2C639DA
6. Snap off the C-clip [1], and remove
A09AF2C005DA
3. Periodical check
roller assy [1].
rear and pull it off the bearing at the
front.
hexagon wrench (2.5 mm), and
remove the weight [2].
the set screw with the weight
slightly pushed against the feed
roller.
the feed roller [2].
17