Soft Switch List - Konica Minolta BIZHUB 163 Service Manual

8. Soft Switch Set
8.6

Soft Switch List

Switch
Bit No.
No.
# 01 - Reserved
8/7 Time between phase C to phase D signal in V.17
6 Header TX selection open to user
# 02
3/2 Transmit RTN signal level criteria
1 Sent N.G page
8 Send out NSF frame with station ID
7 Number of pause within phone number
# 03
6 Re-dial prohibit for NO ANSWER
4/3/2/1 RX level setting
4 Visible alarm for RTN signal
# 04
3 Audible alarm or RTN signal
8/7 Push Button on/off Timing (PB)
6/5 Relation between dialed No. and No. of dial pulse
# 05
3 10PPS/20PPS
2/1 PPS ratio
8/7 Ring on time to ignore ring off time at 1st cycle
# 06
4/3 Ring off time at 1 st. cycle to approve incoming ring
8 Dial tone or busy tone detection
7 PSTN/ PBX setting
# 07 6 PBX dial tone detect
5 Dial mode select
4/3/2/1 Tx level select for PSK/ FSK
8 Sending RTN signal level
7 Detect busy tone after dialing
# 08
6 Sending CED signal after connection
4/3/2/1 Redial interval
8/7 Ringer frequency detection
# 09 5 TSI/ CSI Append "+"
2/1 Time from RX DIS signal to send DCS signal
8 Print out RTN page report
7 Confirmation report result field
6/5 Get gap time between digit for pulse dial
# 10 4 RX PIP T.30 command after send out MPS command
3 Received DIS signal within reception
2 Transmission time limitation
1 Audio alarm after communication fail
7 Detect dial tone after pre-fix number
6 Pulse dial allowed to select
# 11
5 Protocol signal display mode
1 DTMF high frequency dB value
56
Field Service Ver. 1.0 Apr. 2007
Designation Page No.
P.61
P.61
P.62
P.63
P.64
P.64
P.65
P.66
P.67
P.68
P.69