Paper Source Setup - Konica Minolta BIZHUB 163 Service Manual

8. Utility Mode
8.3.2

PAPER SOURCE SETUP

A. INCH/METRIC
Functions • To set the paper size unit of each tray.
Use • To change the size unit of the paper to be used.
NOTE
• If it is not set appropriately, auto detection of paper size cannot be made.
• Tray 2 to 5 can be set only when the optional PF-502 is mounted.
Setting/ • The default setting is METRIC.
Procedure
<Step>
1. Select the tray.
2. Select the appropriate paper size type.
B. TRAY1 PAPER
(1) PAPER SIZE
Functions
• To set the paper size loaded in the tray/1.
Use
Setting/ • The default setting is AUTO.
Procedure
<Step>
1. Select the type of paper.
"AUTO"
• When selecting "SIZE INPUT", enter the size with the numeric keypad.
Setting range : 140 to 432 mm (Width)
• The size registered on [COUSTOME SIZE MEMORY] of [Utility] is set for [Memory1]/
[Memory 2].
NOTE
• When the type of paper is set other than "AUTO", the paper set to the tray 1
cannot be used with Fax mode.
(2) MEDIA TYPE
Functions
• To set the media type loaded in the tray/1.
Use
Setting/ • The default setting is PLAIN.
Procedure
NOTE
• When the media type is set other than "PLAIN", the paper set to the tray 1 can-
not be used with Fax mode.
102
INCH
SIZE INPUT
: 90 to 297 mm (Length)
"PLAIN" TRANSPARENCY
Field Service Ver. 1.0 Apr. 2007
"METRIC"
POSTCARD MEMORY1
CARD
MEMORY2
ENVELOPE