Field Service Ver. 1.0 Apr. 2007
3.5.15
Replacing the developer / toner agitating seal
A. Periodically replaced parts/cycle
• Developer: Every 40,000 prints
B. Procedure
1. Remove the developer scattering prevention plate.
See P.26
[1]
[1]
A09AF2C556DA
[2]
A09AF2C557DA
[1]
A09AF2C629DA
3. Periodical check
2. Dump the developer.
<<How to dump developer>>
• Dump developer [1] on the surface of
the sleeve roller by turning the gear [2]
in the direction of the arrow with the
developing unit tilted as shown.
NOTE
• Turning the gear backward at this
time could damage the mylar for
cleaning the TCR sensor.
• Dump developer until almost no
developer sticks to the sleeve roller.
3. Remove the toner agitating seal [1],
and wipe the sealed surface with
alcohol.
NOTE
• Make sure that the above-men-
tioned procedure is done after the
old developer is removed.
27