10.2 Error Code; Reception - Konica Minolta BIZHUB 163 Service Manual

10. Fax Error

10.2 Error Code

10.2.1

Reception

Code
0001 No G3 signal received within 35 sec. in manual receive mode.
0003 Received DIS after sending DIS signal.
0004 Received DCN after sending DTC signal.
0006 Detect busy tone within receiving phase B.
0009 Can not receive any signal within 35 sec. in manual polling mode.
0010 Received DCN signal after sending DTC signal in polling RX.
0011 Can not receive any correct response after sending three DTC signals.
0012 Remote side Password does not match in polling RX/our side no file to be polled.
0013 Can not receive carrier signal within 6 sec. after sending CFR in data phase C.
0014 Can not receive T.30 signal after sending FTT signal.
0015 Line polarity change within receiving phase B to D.
0016 Receive DCN signal after sending FTT signal.
0017 Can not receive any response from remote side after sending type of xxx_EOM signal.
0018 Can not detect energy within 6 sec. after sending FTT command.
0019 Received DCN signal after sending CFR signal.
001A No energy on line over 6 sec. within phase C before any corrected ECM frame.
001D Detect flag but noting after CER.
0020 Can not correct frame within 6 sec., or in non-ECM mode, one decoding line over 6 sec.
0021 File full
Owing to noise interference on the line, receiving side can't receive correct data within spec-
0022
ified time (no ECM).
- Received "Remote monitoring password" error in RSD.
0023 - The Customer machine has updated the firmware now.
- The Service Tech. Rep. updated remote machine firmware by RSD.
- TX and RX machines both have different "machine ID (FAX model ID)" code in RSD.
0024 - The Customer machine has updated the firmware now.
- The Service Tech. Rep. updated remote machine firmware by RSD
- TX and RX machines have different "company ID (FAX machine maker ID)" code in RSD.
0025 - The Customer machine has updated the firmware now.
- The Service Tech. Rep. updated remote machine firmware by RSD
- Remote monitor level error. Remote side can't access in RSD.
0026 - The Customer machine has updated the firmware now.
- The Service Tech. Rep. updated remote machine firmware by RSD
0027 RSD connect failure due to user incorrect operation or machine error.
0029 Mailbox password not programmed or matched for mailbox receiving.
002A Line Problem
0030 Did not receive any signal within 6 sec.at phase D.
0031 Received incorrect signal at phase D (not EOP, MPS, EOM, DCS PPS_Q, PPS_Q, etc.).
0032 Did not receive carrier signal within 6 sec.after sending MCF. or RTP, RTN signal.
0033 Received DCN signal at phase D within pages (not last page).
In non-ECM mode, when machine already received the data but next line data doesn't
0039
receive within 13.1 seconds.
118
Field Service Ver. 1.0 Apr. 2007
Possible Causes of Error.