Konica Minolta BIZHUB 163 Service Manual page 107

6. Other
[1]
9. Use the two screws to secure the gear to wire pulley 2.
NOTE
• Make sure that the cable pulley is dowelled to the gear.
10. Mount the front and rear cable pulleys onto the shaft and install the shaft to the copier.
Rear Side
11. Fit two Bearings and snap on two C-rings.
72
[1]
A09AF2C515DA
[1]
[2]
A09AF2C516DA
Front Side
A09AF2C517DA
Field Service Ver. 1.0 Apr. 2007
7. Wind the cable on side B around
wire pulley 1 [1] four turns clockwise,
starting with the slit at the top in the
rear left of the pulley.
8. Affix tape [1] to secure the cable to
wire pulley 1 [2].
NOTE
• Install the shaft as shown on the
left.