3. Periodical check
3.5.6
Replacing the imaging unit
A. Procedure
NOTE
• When the developer is to be changed, it is necessary that toner in the recycled
toner recycling duct and toner conveying duct be fed into the developer mixing
chamber. To do that, remove the toner bottle and run "ATDC AUTO ADJUST" twice.
See P.138
1. Open the front door.
2. Open the right door.
[2]
3.5.7
Disassembly of the imaging unit
A. Procedure
20
[1]
A09AF2C007DA
[2]
[1]
A09AF2C535DA
Field Service Ver. 1.0 Apr. 2007
3. Remove two screws [1], and remove
the IU [2].
NOTE
• When installing the IU, use care not
to damage the PC drum.
• Before attempting to install the IU,
be sure to fully open the right door.
Take care that, if the IU is installed
with the right door locked halfway,
it may interfere with the transfer
roller.
• When inserting the IU, do that
slowly and, when you are sure that
the drum gear contacts the mating
part, push the IU all the way into
position. If this step is done all at
once, the drum gear could be dam-
aged.
1. Remove the screw [1] in the rear of
the IU and remove the harness cover
[2].