Maintenance; Firmware Upgrade; Preparations For Firmware Rewriting; Installing The Driver - Konica Minolta BIZHUB 163 Service Manual

Field Service Ver. 1.0 Apr. 2007

Maintenance

2.

Firmware upgrade

2.1

Preparations for firmware rewriting

2.1.1

Installing the driver

NOTE
• The TWAIN driver must previously be installed in the host computer that is used to
upgrade the firmware.
• If the TWAIN driver has not been installed, use the procedure below to install it.
• If the TWAIN driver has already been installed, proceed with the section on "Firm-
ware rewriting" to upgrade the firmware.
See P.5
A. Installation of the GDI printer/TWAIN driver
(1) For Windows XP
1. Start the host computer.
2. Turn on the power switch of the machine.
3. Use a USB cable to connect the machine to host computer.
4. In the "Found New Hardware Wizard" dialog box, choose "Install from a list or specific
location (Advanced)", and then click [Next].
5. Under "Search for the best driver in these locations", choose "Include this location in
the search", and then click [Browse].
6. Specify "\(name of any given language)\WinXP" in the folder in which the TWAIN driver
is stored, and then click [OK].
7. Click [Next] and then [Finish].
8. The "Found New Hardware Wizard" dialog box will appear again: Repeat steps 4~7 to
install all drivers.
(2) For Windows 2000
1. Prepare the files necessary for upgrading the firmware, and copy them to PC.
2. Start the host computer.
3. Turn on the power switch of the machine.
4. Use a USB cable to connect the machine to host computer.
The "Found New Hardware Wizard" dialog box will appear.
5. In the "Install Hardware Device Printers" dialog box, choose "Search for a suitable
driver for my device (recommended)", and then click [Next].
6. In the "Locate Driver Files" dialog box, choose "Specify a location", and then click
[Next].
7. Click [Browse], specify "\(name of any given language)\Win2000" in the folder in which
the TWAIN driver is stored, and then click [OK].
8. Click [OK]. Then, continue following the instructions in the dialog boxes that will appear
until the "Completing the Found New Hardware Wizard" dialog box appears.
9. Click [Finish].
10. The "Found New Hardware Wizard" dialog box will appear again: Repeat steps 4~8 to
install all drivers.
2. Firmware upgrade
3