Connection Of Extension Blocks To Main Unit; Din Rail Mounting - Mitsubishi FX2NC DSS Series Hardware Manual

FX2NC Series Programmable Controllers
3.5

Connection of extension blocks to main unit

1) Remove the
the main unit.
2) Push up the slide lock of the main unit, and
then connect an extension block.
3) Slide down the lock to secure the extension
block.
Connect other extension blocks in the same
way.
3.6

DIN rail mounting

DIN 46277 rail (35 mm, 1.4 inches) can be directly
installed on the FX
(Do not use any screws for this installation.) To remove
the main body, slightly pull down the DIN rail mounting
clip. Slide the clip further, and the rail will be locked with
the clip left open.
To connect the FX
DIN rail mounting clip in the arrow direction as shown to
the right.
cover from the right side of
port
series programmable controller.
2NC
series extension blocks, slide the
2N
Figure 3.5 :
Slide lock
Slide lock
Main unit
Figure 3.6 :
Remove
When DIN rail is
installed
Installation notes 3.
Extension block
Locks the clip.
When directly installed
(before shipment)
3-9