5.4
Output check (Test mode 03)
Status of the output signals can be checked by keying in the following codes in the test mode 03.
<Operation procedure>
Procedure 1
[0][3]
(Code)
[POWER]
Procedure 2
[0][3]
(Code)
[POWER]
Procedure 3
[0][3]
(Code)
[POWER]
Procedure 4
[POWER]
Refer to "Appendix" in this manual for the codes available in the test mode 03.
e-STUDIO556/656/756/856(Ver03)
SELF-DIAGNOSTIC MODE
Operation
[START]
ON
Operation
[START]
One direction
Operation
[START]
[START]
ON
[0][3]
(Code)
Stop
Operation
[START]
code
Test mode
[CLEAR]
standby
Operation
[CLEAR]
OFF
[POWER] OFF
[START]
© 2012 TOSHIBA TEC CORPORATION All rights reserved
5 - 8
[POWER] OFF/ON
OFF
(Exit)
[POWER] OFF/ON
(Exit)
[POWER]
Test mode
OFF/ON
standby
(Exit)