I/O Card Srx5K-40Ge-Sfp Specifications - Juniper SRX5400 Manual

SRX5400, SRX5600, and SRX5800 Services Gateway Card Reference

I/O Card SRX5K-40GE-SFP Specifications

Description
Software release
14
The SRX5K-40GE-SFP I/O card (IOC) is optimized for Ethernet density and supports 40
Gigabit Ethernet ports (see
forwarding and Ethernet interfaces on a single board, with four 10-Gbps Packet Forwarding
Engines. Each Packet Forwarding Engine consists of one I-chip for Layer 3 processing
and one Layer 2 network processor. The IOCs interface with the power supplies and
Switch Control Boards (SCBs).
You must install at least one IOC in the services gateway. The IOC can be of any of the
available IOC or Flex IOC types.
You can install IOCs in any of the slots that are not reserved for Switch Control Boards
(SCBs). If a slot is not occupied by a card, you must install a blank panel to shield the
empty slot and to allow cooling air to circulate properly through the services gateway.
Figure 6: IOC SRX5K-40GE-SFP
OK / F AIL
0/0 0/5
2/0 2/5
1/0 1/5
3/0 3/5
I/O card with 40 Gigabit Ethernet SFP ports
Maximum configurable MTU: 9192 bytes
Maximum throughput: 40 Gbps
Junos OS Release 9.2 and later
Figure 6 on page 14). The IOC assembly combines packet
Copyright © 2016, Juniper Networks, Inc.