I/O Card Srx5K-40Ge-Sfp - Juniper SRX5400 Manual

Services gateway card reference
Hide thumbs Also See for SRX5400:
Table of Contents

Advertisement

SRX5400, SRX5600, and SRX5800 Services Gateway Card Reference

I/O Card SRX5K-40GE-SFP

Description
Software release
Cables and connectors
Controls
Supported Slots
14
The SRX5K-40GE-SFP I/O card (IOC) is optimized for Ethernet density and supports 40
Gigabit Ethernet ports (see
forwarding and Ethernet interfaces on a single board, with four 10-Gbps Packet Forwarding
Engines. Each Packet Forwarding Engine consists of one I-chip for Layer 3 processing
and one Layer 2 network processor. The IOCs interface with the power supplies and
Switch Control Boards (SCBs).
You must install at least one IOC in the services gateway. The IOC can be of any of the
available IOC or Flex IOC types.
You can install IOCs in any of the slots that are not reserved for Switch Control Boards
(SCBs). If a slot is not occupied by a card, you must install a blank panel to shield the
empty slot and to allow cooling air to circulate properly through the services gateway.
Figure 6: IOC SRX5K-40GE-SFP
OK / F AIL
0/0 0/5
2/0 2/5
1/0 1/5
3/0 3/5
I/O card with 40 Gigabit Ethernet SFP ports
Maximum configurable MTU: 9192 bytes
Junos OS Release 9.2 and later
40 Gigabit Ethernet SFP ports
None
SRX5600–Any slot except bottom slots
SRX5800–Any slot except center slots
Figure 6 on page
14). The IOC assembly combines packet
or
0
1
0
,
1
, or
2/6
Copyright © 2014, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Srx5600Srx5800

Table of Contents